Piezas De Repuesto; Grounding Instructions - Danby DIPLOMAT DCRO55W Owner's Manual

PIEZAS de REPUESTO
Modelos
DCRO55W
DCRO55BL
41
A
Sa 30f 29/ 28
se | y
29
Safety Instructions
ATTENTION
GROUNDING INSTRUCTIONS
This appliance must be grounded. in
the event of an electrical short circuit,
grounding reduces the risk of electrical
shock by providing an escape wire for the
electrical current. This appliance is
equipped with a cord having a grounding
wire with a grounding plug. The plug must
be plugged into an outlet that is properly
installed and grounded.
WARNING - Improper use of the
grounding plug can result in a risk of electric
sheck. Consult a qualified electrician or
serviceman if the grounding instructions are
not completely understocd, or if the doubt
exists as to whether the appliance is
properly grounded.
BG NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect
your refrigerator to extension cords or
together with any other appliance in the
same wall outlet. Do not splice the cord.
IMPORTANT WARNING
An empty refrigerator is a very dangerous
attraction to children. Remove either the
gasket, latches,lids or doors from unused
appliances, or take some other action that
will guarantee it harmless.
DANGER: Risk of child entrapment. Before you throw
away your old refrigerator or freezer:
* Take off the doors
+ Leave the shelves in place so that children
may not easily climb inside.
DON'T WAIT DO IT NOW!
Installation
Remove the exterior and interior packings, wipe
the outside thoroughly with a soft dry cloth and
the inside with a wet, lukewarm cloth. Avoid
placing the cabinet in a narrow recess or near
any heat source, direct sunlight, or moisture.
Let air circulate freely around the cabinet. Keep
the rear of the refrigerator 5 inches away from
the wall.
Location
1. Select a place with a strong, level floor.
2. Allow 5 inches of space between the back of
the refrigerator and any adjacent wall.
3. Avoid direct sunlight and heat. Direct
sunlight may affect the acrylic coating.
Heat sources nearby will cause higher
electricity consumption.
4. Avoid very moist places. Too much moisture
in the air will cause frost to form very quickly
on the evaporator, and your refrigerator will r
have to be defrosted very frequently.
Operation
To avoid vibration, the cabinet must be set level.
Adjust the level of the refrigerator using the single
leveling leg located on the lower hinge side of the
cabinet.
To start the refrigerator, turn the temperature
control knob to the position corresponding to the
desired cooling. {on the graduated blue dial)
Fig.A
The refrigerator temperature will vary depending
on the quantity of the food stored and on the
frequency with which the door is opened.
To turn the control to the "O" position, rotate
the centrol knob to the narrowest point on the
graduated dial. After defrosting and if the
refrigerator has been left out of use for some
time, set the control to maximum for 2 to 3 hours
before turning to the desired position. If the
refrigerator is not to be used for long time
periods, disconnect the plug and leave the door
partially open. This will help reuce the
mold/mildew from accumulating inside the
refrigerator cabinet.
Ice Cubes EN
Ice cube tray is flexible. Twist tray
to remove ice cubes. If the ice
cube tray is frozen hard to the Fig. €
evaporator surface, run a little water
over the tray. Never use a knife or other meta!
instrument to remove ice cube tray because this
may damage the evaporator. (Fig. C}