Electrical Connection; Model And Serial Number Location - Kenmore Pro 79046913510 Installation Instructions Manual

WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS
Electrical connection
IMPORTANT Please read carefully.
For personal safety, this appliance must be properly
grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle to minimize the
possibility of electric shock hazard from the appliance.
The wall receptacle and circuit should be checked by
a qualified electrician to make sure the receptacle is
properly grounded.
Where a standard 2-prong wall receptacle is installed,
it is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded
3-prong wall receptacle.
Do not, under any circumstances, cut or remove the third
(ground) prong from the power cord.
PNWVGINING Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
Preferred Method
Do nol, under any
circumstances, cut,
remove, or bypass
the grounding
prong.
Grounding type
wall receptacle
Power supply cord with
3-prong grounding plug.
Model and Serial Number Location
The serial plate is located as shown below.
When ordering parts for or making inquiries about your
Warm & Serve Drawer, always be sure to include the
model and serial numbers and a lot number or letter
from the serial plate.
Serial Plate Location
Combination Warm & Serve Drawer
and Cooktop Installation
Cooktop
Cutout
Warmer
Drawer
Cutout
You can install the warmer drawer in combination
with an electric or gas cooktop. You must follow the
specifications from the installation instructions of the
cooktop to avoid interference with the gas or electric
installation.