Kenwood TS-670 Instruction Manual page 29

@ 4-21 INSTALLING GC-10
SIGISISIGIC
Wirings bound
GC-10 General Coverage Unit
Use of this unit will enable the receiver section of TS-670
for
general coverage. The receiving frequency range
becomes 500 kHz - 30 MHz. (However, 8.83 MHz and
near-by frequencies cannot be received.)
Install the unit in the following sequence.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Remove the top cover of TS-670 using a No.2 Phillips
screwdriver.
The speaker is mounted on the top cover. Take care
not to break the lead wire when removing the top
cover. The speaker lead wire may be unplugged.
Turn the TS-670 over, and remove the bottom cover
using a No.2 Phillips screwdriver.
Install the GC-10 securely with 6 screws in the space
adjacent to the RF unit, as shown at left.
Insert the connectors (2-pin and 7-pin) already wired
to the TS-670 into the connectors Nos. 6 and 5 of
GC-10, respectively.
Insert the connectors coming from GC-10 on the
associated connector of RF unit (see the figure).
Secure the wires with a nylon band according to the
figure as shown.
Replace the bottom cover and then the top cover. Be
sure to reconnect the speaker lead..
27