Kenwood TS-670 Instruction Manual page 12

(5) How to use the RIT control
RIT control
RIT control
(6) How to use the IF SHIFT control
IF SHIFT control
i] —
1, , jooaaals fA
}0 0 0 |oaaG0 |S
© Ss=|5
Oe) ss=o
Turned in © direction
IF filter passband
Turned in ® direction
®
~—
Interfering signal Interfering signal
RIT—®- IF SHIFT RIT—®-IF SHIFT RIT-@- IF SHIFT
0. 0
c) ® oO ® oO @
Turn in © direction to
eliminate interference
from signal ®
Turn in @ direction to
eliminate interference
from signal ®
IF SHIFT Control
10
RIT CONTROL
By using the RIT (Receiver Incremental Tuning) control, the
receive frequency can be shifted approximately +1 kHz
without changing the transmit frequency.
If the frequency of the station you are working changes,
your receiver frequency can be reset by turning the RIT
switch ON, and adjusting the RIT control. Adjusting the
control clockwise increases the frequency.
NOTE:
When first calling another station, the RIT should be
OFF, otherwise your transmit and receive frequency will
not coincide.
IF SHIFT CONTROL
¢ LSB Mode (7 MHz and below)
° CW Mode
By using the IF SHIFT in conjunction with the RIT, tone
quality can be adjusted.