Watchguard V10 Supplementary Manual page 18

4
5
6
7
12
Click the Advanced button.
The Advanced HA Parameters dialog box appears.
To activate monitoring through the HA ports, click to select the
checkbox marked Enable HA on HA1 Port and/or Enable HA on
HA2 Port.
Note that if HA is enabled on the HA2 interface, that interface cannot be used for
management access.
If specific IP addresses have been assigned to the HA ports, type the
IP addresses and Netmasks in each of the two HA Interface fields–
Primary and Secondary. Otherwise the default addresses will be
adequate.
You can enter different IP addresses so that they can be accessed through your
local area network.
When you have finished, click OK to save the parameter entries and
close the Advanced HA Parameters dialog box.
High Availability for Vcontroller and CPM