Table of Contents
Advertisement
HOW TO USE THE REMOTE
TO CONTROL YOUR PLASMA TV
i !iiiii !i!!!ii ill
iiiiii;!ii iiiiiiil;i!;!;i!ii i!i;!
!i!ii:;!iiii i ,iiiiiii i!i;i!Qiii
i!!;!i;i:!ii_iiii_i!i;!!i!_!ii!_i!i!_!ill
ii:!!i!;:!;ilkii;!_:i!_iill
!!iiiii ii i!!iii!iii!iii i ii i
(_) CD, PVR, AMP buttons
When pressed, each of these buttons will blink to indicate the remote is in Audio mode (see page 39).
CHANNEL selector buttons
CHANNEL selector buttons are used to select channels, lock access code, etc.
Enter one. two, or three numbers to select channels.
Enter "0" first for channels 1 to 9, or simply press the single digit channel you
wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the "1" button, wait until two dashes
appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up (A) or down (_').
I NOTE:
The Plasma TV may not receive some channels if you are not in the correct ANTENNA/CABLE
mode (see page 49).
(_
SLEEP button
Press this button to display the sleep timer in the lower center of the screen.
Every subsequent press of this button will add 15 min-
utes to this timer, up to a maximum of three hours. Once set, use INFO when you want to view time remaining,
if the SLEEP but-
ton is pressed while the timer is set. it will reset to the original condition.
(_) INFO button
Press this button when you want to check the channel being received, the picture source, if the channel has stereo (ST) or second
audio program (SAP), the time, CHANNEL ID and if the SLEEP timer is set.
Day/N
Closed
Moc
Captioning
--
3:32 PM
_-
Ant A 22
_-
Stereo
-_
R
_-
10801 Format
_-
_-_1_
_Day
E_44:3 Expanded
-_
Q Off
_.O:00AM
O_mer
--'i3me
--Main
Picture So=_rce
--
Audio Broadcast
--
Broadcast
Rating
--
Signal Format
Wide
Mode
--
Sleep Timer
--
When an S-VIDEO
Input is connected to
VIDEO: 3.
a COMPONENT
VIDEO: Y-PBPR Input
is connected to
VIDEO: 1.
ANTENNA button
The ANT button will select between Antenna A and Antenna B each time the button is pressed.
ANT
TV/RGB button
Press this button to toggle between RGB (Analog) mode and TV mode.
26
Advertisement
Table of Contents
