Table of Contents
Advertisement
Troubleshooting
Try these troubleshooting
tips before making a service call. You may save time and money!
Washer
Symptom
Possible
Cause / Solution
Won't Fill
•
Make sure power cord is plugged all the way into the electrical
outlet.
•
Make sure hot and cold water faucets
are turned on.
•
Make sure that the fill hoses are not kinked or twisted.
•
Pull timer knob out to start
washer.
•
Make sure that the controls are properly set.
•
Make sure that the last spin has been completed.
•
Check the house fuse or circuit breaker.
•
Clean the screens in the water mixing valve and the filter screens located at the faucet
end of the fill hoses. (Owner is responsible for service calls regarding cleaning of the
screens.)
•
Water is being siphoned from the washer during the cycle. Refer to the installation
instructions
to make sure that the drain hose has been properly installed.
Won,t Sta_
Make sure lid is Closed:
Pull timer knob out to Sta_ washer.
Make Sure power Cord is plugged ail the way int0 She electrical
outletl
Make sure ;that the controls are properly Set;
CheCk the house fuse Or circuit breaker.
•
The motor overload protector
may have StOpped the cyc!e; !t wi!l reset itself in two or
three minutes and restart
the Washer automatically
Won't Agitate
•
Make sure lid is closed.
•
Pull timer knob out to start
washer.
•
Make sure power cord is plugged all the way into the electrical
outlet.
•
Check the house fuse or circuit breaker.
•
The motor overload protector
may have stopped the cycle, it will reset itself in two or
three minutes and restart
the washer automatically.
•
Broken drive belt. Call the service person.
Wo_;t Sp n
Make sure !id iS closed
Ru!!timer knob OUt t0 start
washer,
Make sure power Cord is plugged all the way into the electrica! outlet,
Check the l_0use fuse or Circuit breaker.
o The motor overload protecto_
may have stopped the Cycle,!t wi!! reset itself in two or
three minutes and restart
the Washer automatically.
,
BrOkenari_e bei_;Cal!
Stops!Pauses
During Cycle
won,sDrain
•
Pauses are part of the washer's normal operation. The washer will stop (pause) shortly
before the wash and rinse spins.
•
Check the house fuse or circuit breaker.
•
The motor overload protector
may have stopped the cycle, it will reset itself in two or
three minutes and restart
the washer automatically.
'
Make sure drain hose is not kinked orSwiStedl
Make sure drain hose is not Clogged]
'
Make sure drain receptacle is no;c Clogged;
• Refwto
the insta!lal_ion instructi0ns
tO make surethatthe
drain hoSe has been proper!y
installed:
continued
-25-
201472
Advertisement
Table of Contents
