Table of Contents
Advertisement
Installation & Adjustment
Connection between the water inlet hose jointer and the water tap
1.Press the lower end of the locking lever and push down the slider. Remove the
water inlet hose jointer from the water inlet hose component. See Figure 1.
2.Remove the nameplate. Make sure the * is 4mm above the screw nut. See
Figure 6. If the * is less than 4mm above the screw nut. Loosen the screws.
Locking Lever
Water inlet hose
Figure 1
3.Insert the jointer of the water inlet hose on the tap. See Figure 2.If the tap
is too large and the jointer cannot be inserted on the water tap, please loosen the
four screws and remove the bushing in the jointer. The front end of the tap must
be smooth, otherwise it may leak water. See Figure 3.
4.Tighten the four screws evenly. See Figure 4.
5.Turn the screw nut in the arrow direction, see Figure 5. After installation, the * is
less than 2mm above the screw nut. See Figure 6.
Figure 4
Connection between the water inlet hose and the washer
1.Do not remove the water absorption cushion.
Please check if the cushion is dropped or
damaged before use. If it happens please
contact our after-sale department immediately.
2.Put the nut of the water inlet hose on the
valve jointer.
3.Tighten the nut. Swing the hose gently to ensure its
firmly connected.
Water inlet hose jointer
Slider
Philips screw driver
Figure 2
Figure 5
Screw
Nameplate
Screw nut
water absorption cushion
jointer of the water inlet valve
7
Bushing
Figure 3
*
About 4mm
before twisting
About less than
2mm after
twisting
Figure 6
nut of the water inlet hose
Advertisement
Table of Contents
