Bmic Controls & Using The Bmic; Led Indication; Care Of The Bmic - FCS BMIC Operator's Manual

Bmic Controls
The picture below shows the location of the rotary control for volume and sensitivity, LED
and the trigger switch plus the Electrical connections for the headphones / battery charger
and microphone.
Headphones &
Battery charger connection
Microphone connection
Using the Bmic
The Bmic is simple to operate. Select either the probe rods or the tripod unit and screw into
the microphone unit. (Use the tripod foot on hard ground and use the probe rods on soft
ground or when accessing water pipe fittings). Connect the headphones to the connector
and connect the microphone cable to the forward connector. Put on the headphones and
press the trigger button o n t o p o f t h e unit to listen for leaks. The volume/sensitivity
can be adjusted using the rotary control.

LED indication

The LED shows green when the unit is operating and red to indicate low battery power.

Care of the Bmic

The Bmic is rugged and showerproof (to IP65) but contains electronic circuitry and
should be handled with care. It should be kept clean and dry and when necessary cleaned
with a damp cloth.
Rotary volume/
Sensitivity control
Trigger Switch
3
LED