Advertisement
TO PLAY ONLY DESIRED TRACKS
Programming a pause
'|
Inserting a pause in your program can be very useful when carrying
out recording. Press #8 instead of entering a track number.
"PA"
appears on the display.
®
For example, when recording on both sides of a cassette tape,
if you program a pause after the last track to be recorded on
the first side, program playback will pause at that point to allow
you to switch tape sides. To resume program playback after the
player enters pause mode, press #8.
NOTES:
@
A pause can be prograrnmed only when the program procedure
is performed under step mode.
@ A pause cannot be programmed at the beginning of a program,
nor can two pauses be programmed one after the other.
®
A pause inserted in a program is counted as one step.
®
(f @ pause is programmed as the last step of a program, the
player will not enter the pause mode.
To clear all of the program contents
|
td (PD-202)
@
During stop mode, press i.
@® When the disc tray is ejected, the program contents will be
cleared.
CONVENIENT OPERATION FOR RECORDING
1
EDIT
COMPU *eAUTO.
After approx. 1 second
EG be Ka Ea 6g
pit
va
[Eecelet |
Bema
Ss
[ec ey Oe a Se ON
re
PD-102
aa
(Saag
j reacs
Ee,
U &
PD-202
ee
(PD-202)
10
<PRB1182>
En
| Te erase a program
J)
During program mode, press CLEAR.
>
The last program step is erased and the contents of the previous
program step are displayed.
NOTE:
Contents of a program can be erased during playback as well.
However, tracks preceding the currently playing track cannot be
erased in this way.
With this function, tracks are automatically programmed for both
sides of the tape.
COMPU PROGRAM EDIT
x
The player automatically rearranges the order in which tracks are
played back so that their total playing time becomes the specified
playing time as near as possibile.
AUTO PROGRAM EDIT
Tracks are selected within the designated time, starting from the first
track and progressing in order,
1 Select the Compu
Program
Edit mode
or Auto
Program Edit mode with COMPU/AUTO
EDIT.
To enter the Compu Program Edit mode:
Press the button
once. "COMPU" appears on the display. After approximately 1
second "TIME?" appears on the display.
To enter the Auto Program Edit mode: Press the button twice,
"AUTO" appears on the display. After approximately 1 second
"TIME?" appears on the display.
To program all tracks on the disc:
not perform step 2.
in about three seconds, the player will automatically select the
tape length (46, 60 or 80 minutes} which will allow recording of
all tracks on the disc, then program the track:
press the button once and do
Advertisement
