GE WPGT9350 Technical Service Manual page 37

1. Remove the rotor. (See Motor Assembly)
Lac
pem
c rm
urn
dep iu
the clutch coupler plate.
1. Remove the Motor Assembly and Clutch
Shifter Assembly.
2. Remove the screw that holds the ground wire
1o the bearing housing. Remove all the.
10-mm hex-head screws on the bearing
housing assembly
3. Remove the clutch coupler assembly.
4. Disconnect the wiring connector from the
clutch motor.
5. Remove the two 10-mm hex-head screws
that hold the clutch motor in place. Remove
the clutch motor.
Note: When reassembling, be sure to put the
motor and Hall sensor wires back in the wiring
guard away from the motor.
Есте