Table of Contents
Advertisement
ERROR CODE AND TROUBLESHOOTING
►
If there is a fault, the charger will stop generating current and will not charge.
►
Charging should be resumed after the fault is checked and corrected.
LED status
Flash 1 time
Flash 2 times
Flash 3 times
Grounding (PE) Disconnection
Flash 4 times
Over-voltage / under-voltage
Flash 5 times
Flash 6 times
Flash 7 times
Flash 8 times
Current control
Delayed charging
time
Standard
Real-time monitoring includes welding detection, temperature detection, PE connection detection, overvoltage detection, overcurrent detection
and CP voltage detection, any failure will be displayed according to the above table.
Reason
RCD leakage protection
Excess current
Welding fault
CP voltage error
Excessive temperature
Loss of diode
for 2 seconds until all green LEDs start flashing, and n then click the button to select the current from 6A to 32A."
LCD error code
1
2
3
Turn off the power and check the distribution network
4
Turn off the power and check the distribution network
5
6
7
8
"Touch
"Click
to set the delay time ła ania from 0 to 5 hours"
IEC62196-2IEC62752
Solution
Switch off and check the electric car and charger
Turn off and check your electric car
Please contact the manufacturer
Check that the connector is tight
Check the heat dissipation of the case
Check EV CP diodes
Advertisement
Table of Contents
