Advertisement
English
Introduction
Information for users in the UK
This colour monitor (depending on the
technical execution) is suitable for use
with home and personal computers,
video recorders, LaserVision players
and TV Tuners.
Important
NOTE: NOT ALL THE INFORMATION
IN THIS BOOKLET IS RELEVANT TO
YOUR MONITOR.
Check the technical information chart
for the exact specifications of your
CM 88* * monitor.
The drawings in the text are
accompanied by figures, e.g.
D.
These
correspond to the figures on the
fold-out flap. This enables you to easily
find the corresponding buttons on the
monitor.
(Not applicable outside the UK)
Service for you
Your monitor has been designed and manufactured to the
highest standards, and subject to rigorous testing. Provided it is
properly operated and maintained it will perform well for many
years. However, we all know that in such complex equipment
components can sometimes fail.
The legal responsibility for meeting any in-guarantee service
needs for your receiver rests with the dealer from whom you
bought it. Our own Service Division - Philips Service - provides
your dealer with comprehensive technical advice, and distributes
approved spare parts from Service Centres throughout the
country. If your dealer has no service facilities, he can arrange for
any work to be carried out by a competent third party
organisation.
In any event you may expect speedy attention to restore your set
to full working order without delay.
Free service for 12 months:
The dealer from whom the monitor was purchased will arrange for
any defect in manufacture or material to be rectified without
charge for a period of 12 months from the date of initial
consumer sale provided:
• reasonable evidence is supplied that the set was purchased
within 12 months prior to the date of claim
• the defect is not due to use of the monitor on an incorrect
voltage or contrary to the Company's Operating Instructions or to
accidental damage (whether in transit or otherwise); misuse;
neglect; unauthorised or inexpert modification or repair.
The picture tube of your monitor is separately guaranteed for 12
months by Philips Service.
Service after 12 months:
Continuing service after 12 months is available in the same way
but the service will be chargeable.
These statements do not affect your statutory rights as a
consumer.
Connection to the mains
Your new monitor is designed to operate from an a.c. mains
supply of 220-240 volts, 50 Hz. Stabilising circuits ensure
satisfactory performance within normal supply variations.
IMPORTANT:
this apparatus must be earthed. This can be achieved by fitting a
3 pin plug. The wires in the earthed mains lead are coloured
according to the following code
BLUE = NEUTRAL
BROWN = LIVE
GREEN/YELLOW = EARTH
If the mains plug (or adaptor) contains a fuse, the value of this
fuse should be 3 Amp. Alternatively, if another type of plug (not
fused) is used, the fuse at the distribution board should not be
greater than 5 Amp.
If the colours of the wires in the mains lead do not correspond
with the coloured markings identifying the terminals in your plug,
proceed as follows ...
The BLUE wire should be connected to the terminal marked 'N'
or coloured black.
The BROWN wire should be connected to the terminal marked 'L'
or coloured red.
The GREEN and YELLOW wire must be connected to the
terminal in the plug marked by 'E' or the earth symbol 4-, or
coloured green or green and yellow.
Before replacing the plug cover, make certain that the cord grip
is clamped over the sheath of the lead - not simply over the three
wires.
1
Advertisement
