Subscribe to Our Youtube Channel
Related Manuals for Teknion SWERV
Summary of Contents for Teknion SWERV
- Page 1 Installation Guides ELECTRICAL Section: Date: Sep 2023 Page No: 1 of 8 Description: SWERV USB HUB, SINGLE COM_502 Rev. No: 1 SWERV USB HUB (YMSUS)
- Page 2 Installation Guides Section: ELECTRICAL Date: Sep 2023 Page No: 2 of 8 Description: SWERV USB HUB, SINGLE COM_502 Rev. No: 1 Part and Product Identification A2 - YMSUSS(SWERV USB) EDGE CLAMP KIT (MPN10-E011) x1 C - TRANSFORMER BRKT, E - P-CLIP 3/8" CORD,...
- Page 3 ELECTRICAL Date: Sep 2023 Page No: 3 of 8 Description: SWERV USB HUB, SINGLE COM_502 ASSEMBLY FOR YMSUSSM1A_ & YMSUSHM1A_ ASSEMBLY FOR YMSUSSM1A_ & YMSUSHM1A_ 4.9" 2.5" STEP 1: Pre-drilled 7/64" diam. hole. Location on the Worksurface as specified in the STEP 1a: Plug in the power supply cable end in the USB hub.
- Page 4 STEP 1a: Plug the end of the power supply cable in the USB hub as shown. Then, place the back of Swerv USB hub. edge clamp with USB hub on worksurface and secure the edge clamp by turning the thumb screw clockwise.
- Page 5 Page No: 5 of 8 Description: SWERV USB HUB< SINGLE COM_502 ASSEMBLY FOR MAGNET MOUNT STEP 1: Attach Magnet Mount to bottom of worksurface using the Open Cell Sponge Rubber on the opposite side of the Magnet Mount. Plug the end of the power supply cable in the USB Hub.
-
Page 6: Connecting Power Adapter
Date: Sep 2023 Page No: 6 of 8 Description: SWERV USB HUB, SINGLE COM_502 ATTACHING POWER ADAPTER CONNECTING POWER ADAPTER STEP 2: Position the bracket onto the worksurface with the Power Supply (D) beneath it as STEP 3: Plug in one end of the linking jumper in the USB module and the other end in the shown above. - Page 7 Date: Sep 2023 Page No: 7 of 8 Description: SWERV USB HUB, SINGLE COM_502 Attaching P-Clip Attaching P-Clip STEP 4: Drill a 7/64" diam. hole next to the wire. Ensure to keep a distance of more than 4" STEP 5: Place the P-clip on the wire and secure it with the worksurface using the provided screw.
- Page 8 ELECTRICAL Date: Sep 2023 Page No: 8 of 8 Description: SWERV USB HUB, SINGLE COM_502 ATTACH ADHESIVE CLIP FOR WIRE STEP 4: Attach Adhesive Clip to bottom of worksurface using adhesive tape on bottom of clip. Insert wire into Clip.
Need help?
Do you have a question about the SWERV and is the answer not in the manual?
Questions and answers