Pioneer PD-J900M Service Manual page 67

PD-Z74T
groove shown in Fig. 2-15, and rotate the idler gear
clockwise, and tray II is clamped.
Further, rotate the idler gear, the pin pressing the switch
appears at B position.When the pin moves to A position,
stop the gear rotation. The gear I reaches to a position
shown in the figure. At this position, attach the tray I.
(2) As shown in Fig. 2~16, adjust the first tooth of the tray I to
the clogged part of the gear I, then push in the tray I slowly.
Clogged part
Fig. 2-16
2.8 STYLING
(1) Bend the wires as shown in Fig. 2-17.
The reverse side of the loading base.
lal
:
Place the wire material along the rib,
and after hooking it, fix with the binder.
Binder |
Fix the wire material to this rib with the binder.
-
an
nean
Fig. 2-17