PD-Z 74T
2.
REASSEMBLY
2.1
ASSEMBLY
OF
CLAMPER
CAM
AND
FLOATING BASE
(1) As shown in Fig. 2-1, adjust the notches (3 points) in the
clamper cam to the claws (3 points) of the loading base, and
set the clamper cam to the position as the arrow shows.
Clamper cam
Loading base
Fig. 2—1
(2) After adjusting the notches in the clamper cam to the claws
(3 points) showing in Fig. 2-1, place the protrusions of the
floating base on the grooves (2 points) of loading base as the
arrow shows in Fig. 2-2.
Protrusions
Floati
loating base
Adjust the notches in
| the clamper cam to the
groove of loading base.
Loading base
Fig. 2-2
(3) Rotate the clamper cam in the direction of the arrow A, and
stop the rotation when the floating base reaches to the lowest
position.
Note: Keep the floating base to the lowest position till the
assembling of the main cam, follow gear, gear I, gear HI,
clamper arm U and B is completed.