the label attached on the motor faces the direction illustrated.
*1: Fix the motor
on the loading board assembly
so that
Wea
ae
ae
a
'*2: Fix the motor
on the motor board
assembly
so that the label
attached on the motor faces the
direction illustrated.
¢ How to install the disc table
[7] Use nippers or other too! to cut the two sections
marked ® and the three sections marked © in
figure [1]. Then remove the spacer.
[2] While supporting the spindle motor shaft with
the stopper, pul spacer on top of yoke M, and
stick the disc table on top (takes about 9kg press-
ure). Take off the spacer.
ka
Spindie motor
mounting position