INSTALLATION
DOME
· Position the dome so that the coax(s) and the control cable connection point to the rear of
the RV.
· Position the dome away from anything that could obstruct the view of the dish.
· Locate a position on the roof that will provide a solid attachment point.
· Seal all holes and screws with the proper sealant recommended for the roof of your RV.
· Use a dielectric grease to protect all electrical connections.
· Use supplied 9 conductor cable for dome to controller connection
· If operating more that one receiver, run two (2) coax cables.
CONTROLLER
· Place the controller in a location that is accessible for ease of operation.
· Always use the 110V AC to 12V DC 4 Amp Power Supply provided.
· Firmly tighten (do not over tighten) all coax connectors to insure good connection.
· Make sure that all screws are tight on the 9 pin green connector on the back of the
controller. Wiring color code is on the bottom of the controller and on the green
connector.
· Check for any stray strands of wire which could cause a short.
CABLE ROUTING
Control Cable
· From the Dome to the back of the Freedom Controller
Coax Cable (RG6)
· The system will not perform a search for the satellite without a coax connected to
the Controller.
First Coax (RG6)
· From the Dome to the back of the Freedom Controller
· From the Freedom Controller to the Satellite Receiver (sat in)
· From the Satellite Receiver to an optional Distribution switch to the TV or...
· From the Satellite Receiver to the TV
Optional Second Coax (RG6) (not supplied)
· From the second (2
Receiver
· From the second (2
For any questions or comments please contact our
Technical Support Department at 18002477486.
nd
) coax connection on the Dome to the second (2
nd
) Satellite Receiver to the second (2
Operation and Installation Manual
nd
nd
) TV
) Satellite
5