Your Audio/Video Devices; Device Code Setup; Seardling And Sampling T - Toshiba COLORSTRAM 26HL84 Owner's Manual

Programming the remote control for use with
your audio/video devices
Device code setup
i. Refer to the Device code table on pages 23-24 to f_nd the code
fbr the brand of'your device.
]If'more titan one nunlber is listed, try each one separately until
you f_nd the one that works.
2. Press MODE mltil the Mode indicator of"the device (CABLE/
SAT, VCR, DVD, AUDIO 1, AUDIO2) lights ttp.
3. Willie holding down tlle RECALL button, press the Cllannel
Number buttons to enter the four-digit code of your brand of"
device. If"a valid code is entered, tlle mode indicator will blink
twice. If'an im#alid code is entered, the mode indicator will blink
one long blink.
4. Point tl_e remote control at the device and press POWER to test
the code.
lf"tile device t_trns om you leave entered the correct code.
If"the device does not respond to ti_e remote control, you may
Lave entered the wrong code. Repeat steps 3 and 4 using another
code,
5. Press MODE to select the TV mode to control the TV.
Note:
• Every tfme you re/a/ac;e tile batler/es, you
must repr_gmm tfle remote (-ootfeL
• Some newer VCRs are capable of wet?i/W
of} either of lwo remote code& These VCRs
have a swit_Thlabeled "VCR Z/VCR2"
ff your VCR has this kind of switch arid
does not respond to any of ff_e codes for
your VCR brand, set the switch to the other
positron (VCRZ or VCR2_ and fepre_,mm
ff?e remote cor_l/e/
mere
{i
Searching and sampling the code of a device (8500)
][_you do not know the device code for
a particular target unit,
yo_t
can cycle rl_e remote control tl_rough the available codes for that
device mode and sample the f:_mctions to find the code that properly
operates the target device. The keys available to be sampled, provided
they are applicable to that mode, are POWER, 1, VOL _, CH _, and
PLAY. invalid keys will be ignored while in program mode.
To cycle through each available device code and sample its f:_mctions:
1. Press MODE to select the mode you want to set up.
2. Wt_ile holding down the RECALL button, press 8 -5 -0 -0.
The remote control will enter program mode.
3. Point the remote control at tJ_e target device and press POWER
(or other f:_mction buttons that are available to be sampled).
4. If'the device responds to the remote control:
Press RECALL to store t_'_edevice code.
The mode indicator will blink twice and the remote control
will exit the program mode.
If"the device does not respond to the remote control:
Press A, and tl_en press POWER.
Repeat this step until d_e device responds to the remote
control, and then press RECALL.
Note:
When a seamh cycle is completed UTemoo'e kTdicator will blink
three t/7Y_es, T he remote c;ont7o/ will bogie to c',ycle ff_lough the
available codes agaio, fine key is pressed will,in _0 seconds wi_ile
pmcjramming, the remote oor_trel will exit the program mode and
_ettlm to 27eprevious r;ode
POWER
Numbers
MODE
RECALL
....... ii,ii:
21 iiiiiiiiiiii ¸