Checking/Adding Gasoline; Lubricating The Tractor; Checking The Fuel Filter - Simplicity 4200 Series Operator's Manual

Normal Care
CHECKING/ADDING GASOLINE
Check the gas gauge/cap to be sure there is
enough gasoline to complete the job. To add
gasoline, remove the gas gauge/cap. Refer
to your engine manual for gasoline recom¬
mendations. Install and hand tighten the gas
gauge/cap.
LUBRICATING THE TRACTOR
Lubricate the tractor as shown in figures 9
thru 12. When a grease gun is shown, wipe
the fitting clean, apply two or three shots of
lithium base automotive grease, and wipe off
excess grease. When an oil can is shown wipe
the area clean, apply a few drops of oil (SAE
30), then wipe up drips or spills.
Figure 9. Shift Lever Lubrication
Figure 10. PTO Lever Lubrication
Figure 11. Front Axle Lubrication
(Two grease fittings on each side)
Figure 12. Clutch & Brake Rod
Lubrication
CHECKING THE FUEL FILTER
^^WARNING
Do not remove fuel filter when engine
is hot, as spilled gasoline may ignite.
Do not spread hose clamps further
than necessary. Insure clamps grip
hoses firmly over filter after installa¬
tion.
11