Tally Lamp - Canon ELURA 50 Instruction Manual

ii!i !igiiii!iiiiii!ii if y our wi ,e eootrol,er isn't workin
Make sure the camcorder and the wireless controller are both set to the same
mode. Check the mode the camcorder is set to by pushing any button other than
the REMOTE SET button oi1 the wireless controller. The camcorder's mode
appears in purple for about 4 seconds. Set the wireless controller's mode
accordingly by pressing ttle aforementioned button combinations. If tile wireless
controller still doesn't work, change the batteries.
[] Notes:
• The mode file camcorder
is set to also appears lbr 4 seconds when you turn the
power on.
• When you replace flae batteries, the wireless controller returns to mode 1.
Change flae mode again if necessary.
.c "8
The tally lamp lets you know that the
camera is recording, receiving signals
from the wireless controller or
counting down for the self-timer.
However, its flashing may be reflected
into the lens during close-up recording,
or when recording through glass.
You may therefore decide to turn it off.
o°
To turn the tally lamp off, open the menu and select SYSTEM. Then
select TALLY LAMP, set it to OFF and close the menu.
• The tally lamp no longer flashes during recording, but it will still light up when
the camera receives a signal from the wireless comroller and during the self-
timer counrdown.
5O