Kenwood TK-230 Service Manual page 9

WRITING. METHOD
2. Programming
2-1. Notes for writing
1. Before connecting an option to the universal con-
nector of the radio, be sure to turn the radio
POWER switch off.
2. Alphanumeric data of the channel or repertory dial
cannot be written by writing by the radio.
3. The IF and PLL step cannot be modified by writing
by the radio. Thereforem write the data by using
KPT-20 + (2R).
4. Each frequency data item and tone data item is
written into the ROM for each system. To modify
system data, perform the operation until the next
number of the modified system number appears,
SSS2)!
TK-230
then perform the next operation. ~
Programming
plug (KCT-2)
Front panel with keyboard
(KDM-4)
2-2. Setting
- Self programming
1. Remove the TK-230 front panel ( @ ), and mount a
keyboard on the front pane! (@). (Or obtain a
TK-230 with keyboard.)
2. Turn OFF the power switch of the TK-230 with key-
board off and mount the KCT-2 on the universal con-
nector (@).
3. The TK-230 has the ROM writer function ( @).
: Cloning to another TK-230 (all copy)
1. Turn the power switch of the TK-230 and another
TK-230 with the ROM writer function off.
2. Connect the end of the KCT-1 cloning cable, which
ULE
has a red tag, to the universal connector of the ROM |
writer, and connect the other end to the universal con-
Ree
nector of the TK-230 to which the data is to be ROM writer ~~
written.
3. Turn the writer POWER switch on, and then turn the
POWER switch of the next set to which data is to be
written on. om ra) om rs)
4. The set LCD indicates WRITER.
Subsequently, the
=>
>
data is sent to the set to which data to be written.
A
Pe
a . LJ
Cloning cable (KCT-1) Hf
CAUTION : Before connecting programming plug
KCT-2 or cable KCT-1 to the universal connector, be
sure to turn the POWER switch of the set off.
re)
ROM writer