Kenwood TK-230 Service Manual page 20

DISASSEMBLY FOR REPAIR
10. TX-RX unit removal
1. Remove the 4 screws from the shielding plate (@ ).
2. Lift up the shielding plate (@).
3. Remove the 2 screws from the bottom plate ( @).
11. Universal connector removal
1. Resolder the shielding plate and RF coaxial ground
wiring from the universal connector ( @).
2. Remove the screw from the frame (Q).
3. Lift the shielding plate as shown (@).
4. Push out the universal connector from the inside
(@).
5. Lift the universal connector slowly as shown ( @).
20