Omega MONTMELO 260 User Manual page 32

EN
c) Idle screw (fig. F17)
This is the screw to adjust the engine rotation when the throttle lever is set to the lowest speed
position. Turning to the right (clockwise) increases the rotation and turning to the left (counter-
clockwise) decreases it. In case the blade continues to rotate or the engine stops when you put
the throttle lever fully to the original position, perform readjustment.
(1) Idle adjustment screw
(2) High
(3) Low
4. Maintenance before storage
1. Brush off any dirt that has formed on the machine, check for damage or looseness of each part. If you discover abnormalities,
repair them for the next use.
2. Drain fuel from tank and loosen float booth drain screw to drain fuel. Start the engine and let it run until it stops naturally.
3. Drain fuel from tank and loosen float booth drain screw to drain fuel. Start the engine and let it run until it stops naturally.
4. Apply anti-rust oil to the metal parts, such as the throttle cable, put the cover on the blade, and store the machine indoors
avoiding moisture.
14