Omega MONTMELO 260 User Manual page 31

EN
important
A clogged air filter can increase fuel consumption and reduce engine power. Using the brushcutter without
the air filter with a deformed filter element will quickly deteriorate the engine.
b) Fuel filter
Pull the filter out of its location using a small wire hanger. Disconnect filter assembly from fuel line and unhook retainer to remove.
Clean components with gasoline.
important
A clogged fuel filter can cause a loss of engine acceleration.
c) Spark plug (fig. F15)
Remove and inspect the spark plug and clean the electrodes as needed with a brush.
The spark gap should be adjusted to 0.6-0.7mm.
d) Air cooling vent socket
Check the intake air cooling fan and the area around the cylinder cooling fins. Remove any debris
that has adhered to the brushcutter.
important
Be aware that failure to do so could cause the muffler to overheat and in turn
ignite the brushcutter.
e) Gearbox (fig. F16)
Apply multipurpose grease every 25 hours of use.
Remove the cutter supports to allow the old grease to drain out.
3. After 100 hours of use
a) Muffler
1. Remove muffler, insert screwdriver into outlet and clean out any carbon buildup. Clean any carbon buildup from the muffler
exhaust duct at the same time.
2. Tighten all screws, bolts, and hardware.
3. Check whether oil or grease has found its way between the clutch facing and the drum, and if so, remove it using oil-free
unleaded gasoline.
4. Remove carburetor float seat and clean interior.
b) Carburetor adjustment
An incorrect setting can cause damage to your unit. If the engine does not run smoothly after adjusting the carburetor, contact the
store where you purchased the product.
13