Advertisement
There is a three-way switch located on the top panel between the two BNC RF inputs. This
switch has three positions: "OFF," main power "ON" and main power and remote ANTENNA
PWR switched on. The switch utilizes a light up LED switch handle. When used in normal mode,
the switch batt lights up GREEN. When the unit is switched to also provide remote antenna
power, the switch lights up RED. The entire unit is powered from any source of external DC
power of 7 to 18Vdc @ approximately 120 mA.
1. Connect a source of external 12Vdc power to the Hirose 4 pin connector on the
bottom of the unit.
2. Connect your two receiver antennas to the RF input BNC connectors on the top of the
unit.
3. Connect the PSC RF Multi Mini to your receivers using the appropriate cables from the
RF output SMA connectors on the RF Multi Mini to the RF antenna connectors on your
receivers.
4. Power up the unit. When using powered antennas or remote line amplifiers, turn the
power switch to "ANT PWR." For all other uses, Turn the switch to "ON."
*NOTE* When used with ENG "bag" mixing setups, we recommend that you remotely
mount your receive antennas up away from your equipment on your bag's shoulder
straps. Alternately, you can mount your two receive antennas down and out in front
of your bag. The main idea is the make sure that your receive antennas as not in the
same plane (at the same height) as any transmitter antennas in your bag in order to
minimize receiver Rf overload form near by transmitters.
INSTRUCTIONS FOR USE:
Advertisement
