Table of Contents
Advertisement
LOCATE, SKIP OPERATIONS
B Locate Operation
Use this operation to move the stylus to a chosen position dur-
ing play.
(1) Press the LOCATE/SKIP switch (<I
or >)
and move
the tonearm to the desired position.
@ Press the tonearm elevation switch to begin playback.
&@ Skip Operation
Use this function during programmed play to move ahead to
the next programmed track, or backwards to previous tracks.
®
When the («¢<J) switch is pressed once, the stylus will be
moved
to the next programmed
track. If the switch is
pressed repeatedly within a 1-second interval, the stylus
will move forward the number of tracks corresponding to
the number of times the switch is pressed.
e
When the (>
}) switch is pressed once, the stylus will
move back to the beginning of the presently playing track.
If pressed repeatedly within a 1-second interval, the stylus
will move backward the number of tracks corresponding to
the number of times the switch is pressed.
RECORD
PLAY
SYNCHRO
RECORDING
When the deck contro! terminal on this turntable is connected
to the player control terminal on the Pioneer tape deck (C7
Z99W),
the turntable's
operation
will
be linked
to the
recording
operation
of the
tape
deck.
This
function
is
convenient when
recording the contents of a record onto
cassette tape.
e
This function operates with auto play, programmed
play,
and repeat play.
®
The necessary connecting cord is an accessory of the tape
deck.
®
For operation, refer to the Operating Instructions accompa-
nying the tape deck.
ADJUSTING THE STYLUS DESCENT POSITION
Make adjustments in the following situations:
e
When the stylus does not descend properly between tracks
with
normal
programmed
play
(with
the
SENSOR
switch at the ''N" position for ordinary records).
e
When the stylus has been replaced.
(1) Perform steps (1) through (4) of RECORD
PLAY
PROCEDURE.
(A normal 30 cm
LP
record is placed on the platter).
(2) Perform
programmed
play (not track 1)
and check how far the stylus deviates.
(3) Rotate
the headshell
adjusting
screw
as
follows,
using a small slot-head screw-driver,
in accordance with the amount of deviation:
®
Stylus descends on the outside of the programmed track:
Rotate the screw counterclockwise.
e
Stylus descends on the inside of the programmes! track:
Rotate the screw clockwise
(4) Check the adjustments.
After making the above adjustments, test the programmed
play function
(skipping the first track) to make
sure the
stylus descends properly between each track on the recard.
If the descent position js still off, perform steps (3) through
(4) again.
Advertisement
Table of Contents
