Operation - Glacier bay 67569W-6001 Installation And Care Manual

Installation (continued)
8
Installing the lift rod
□
Slide the lift rod (Q) through the faucet assembly (A)
until the knob rests on the faucet assembly.
□
Push the pivot rod (L) to the down position until
the stopper (F) is completely open. Press the
button (M) on the slip joint assembly (N) and
adjust the vertical rod (O) up or down and front
or back along the pivot rod (L) until the vertical
rod (O) is in the correct position to engage with
the lift rod (Q). Press lift rod (Q) into the top of the
vertical rod (O) until it engages.
□
Operate the lift rod (Q) up and down to verify that
the stopper opens and closes correctly.

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator with the coin (AA) to ush the water lines.
□
Turn on the water supply and allow both hot
and cold water to run for at least one minute
each. This ushes away any debris that could
cause damage to internal parts.
□
While the water is running, check for leaks.
□
Turn off the water and replace the aerator.
A
F
AA
7
Please contact 1-855-HD-GLACIER for further assistance.
Q
O
M
L
N
L
N
HOMEDEPOT.COM
M