Installation - Glacier bay 67569W-6001 Installation And Care Manual

Installation

1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Place the spout assembly (A) through the middle
mounting hole in the sink.
□
Secure the spout assembly (A) with the washer
(D) and the nut (E). Use the basin wrench to
tighten the nut (E).
NOTE: This step is for no escutcheon installation (optional).
If the escutcheon will be used, install the faucet assembly
as described in step 2.
D
3
Making the waterline
connections
NOTE: The hot side inlet tube is indcated by a label.
If the label is not present, the hot supply tube is the longer
of the two inlet tubes.
□
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
NOTE: Before tightening the faucet connector to the water
supply, apply a second wrench to the supply tube tting.
This will prevent the supply tube from moving or twisting
when tightening the faucet connector. Do not overtighten.
A
E
2
Installing the faucet assembly
NOTE: This step is for escutcheon installation (optional).
If the escutcheon will not be used, install the faucet
assembly as described in step 1.
□
Place the escutcheon (B) and the gasket (C) on
the bottom of the new faucet assembly (A).
□
Place the faucet assembly (A) through the
mounting holes in the sink.
□
Secure the spout assembly (A) with the washer
(D) and the nut (E). Use the basin wrench to
tighten the nut (E).
NOTE: If the sink is uneven, use silicone under the
gasket (C).
1
3
4
A
B
C
D
E
2