Advertisement
PART LIST
No
Sketch
Description
A
Dresser
STEP 1
A
STEP 3
A
MADE IN MALAYSIA
ASSEMBLY INSTRUCTION
ITEM NO : 1444-5 DRESSER
Thank you for purchasing this product. Please take time to read and follow the instructions below.
Check that you have all parts and hardware before assembly. Parts apparently missing are often
found in the packing materials. If you do not have all the parts listed, have your dealer contact us
and they will be sent to you immediately
It is recommended to install protective pads under all legs and support to avoid damage or
scratches when placing furniture on a wood floor or other hard surface, and to limit
indentation and prevent discoloration if placing on carpet.
Hardware may loosen over time. Periodically check to make sure all connections are tight. Re-
tighten if necessary.
Quantity
No
1
* ABOVE HARDWARE ARE PACKED IN 1444-5 FOR ASSEMBLY
1
4
4
4
3
.
HARDWARE LIST FOR ANTI - TIPPING KIT
Description
Size
M4 x 16mm
1
Screw
2
Screw
M4 x 50mm
Strap
3
4
L Bracket
STEP 2
WALL
A
NOTE
Tipping Restraint hardware kit is included
with this product. Refer to installation
instruction in the hardware pack.
* ANTI-TIPPING HARDWARE PACK IS AT THE BACK PANEL
Sketch
Quantity
1
1
1
2
4
2
PAGE 1 OF 1
Advertisement
