Advertisement
Quick Links
Autorisierter Distributor
17xx Clamp Adapter
Introduction
The 17xx Clamp Adapter is an accessory for the 17xx-series
of Power Quality Analyzers. Use the adapter to connect the
current clamp with the BNC connector to the 17xx Analyzer.
This adapter is ready-to-use for all clamps with a ratio of
1 mV/A. Select the adapter version depending on the voltage
output of the clamp:
Maximum 1 V: Supports clamps with a range from
0.2 A RMS to 1000 A RMS or up to ±1500 A DC
Maximum 2.8 V: Supports clamps with a range from
4 A RMS to 2800 A RMS or up to ±4000 A DC
See
Supported Clamp Models
configuration on the 17xx Analyzer and a clamp with a ratio
other than 1 mV/A.
Connector to 17xx Analyzer
Label with maximum clamp output voltage
BNC connector to Clamp cable
PN 5382413 (English)
10/2022
©2022 Fluke Corporation. All rights reserved. Specifications are
subject to change without notice. All Product names are
trademarks of their respective companies.
BNC Adapter for Clamps
for the required measurement
1
2
Instructions
3
Advertisement
Related Manuals for Fluke 17XX-CLAMP-ADPT-2V8
Summary of Contents for Fluke 17XX-CLAMP-ADPT-2V8
- Page 1 Label with maximum clamp output voltage BNC connector to Clamp cable PN 5382413 (English) 10/2022 ©2022 Fluke Corporation. All rights reserved. Specifications are subject to change without notice. All Product names are trademarks of their respective companies.
-
Page 2: Contact Fluke
Contact Fluke Fluke Corporation operates worldwide. For local contact information, go to our website: www.fluke.com. To register your product, or to view, print, or download the latest manual or manual supplement, go to our website: www.fluke.com/productinfo Fluke Corporation Fluke Europe B.V. - Page 3 The affixed label indicates that you must not discard this electrical/electronic product in domestic household waste. Do not dispose of this product as unsorted municipal waste. For information about take-back and recycling programs available in your country, see the Fluke website.
- Page 4 Supported Clamp Models Scale Sensitivity Range Adapter Range Factor i1000s AC 100 mV/A 0.1 A to 10 A 0.01:1 10 mV/A 0.1 A to 100 A 0.1:1 Auto 1 mV/A 1 A to 1000 A i3000s AC 10 mV/A 1 A to 30 A 0.1:1 1 mV/A 1 A to 300 A...
- Page 5 17xx Analyzer. 2. Apply the required scaling factor and range that is specific for the attached clamp. Note Fluke strongly recommends to use the low range with the 2.8 V adapter. The higher range may distort the signal.
-
Page 6: Specifications
≤45 % RH (at 40 °C to 50 °C) LIMITED WARRANTY This Fluke product will be free from defects in material and workmanship for 1 year from the date of purchase. This warranty does not cover fuses, disposable batteries, or...