Table of Contents
Advertisement
To exit the basic settings, use
6.
main menu or switch off the appliance using
a The changes are saved.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
13.3 Setting the time
Press "Basic settings" in the menu.
1.
Home Connect
14 Home Connect
This appliance is network-capable. Connecting your ap-
pliance to a mobile device lets you control its functions
via the Home Connect app, adjust its basic settings
and monitor its operating status.
The Home Connect services are not available in every
country. The availability of the Home Connect function
depends on the availability of Home Connect services
in your country. You can find information about this at:
www.home-connect.com.
The Home Connect app guides you through the entire
login process. Follow the instructions in the Home Con-
nect app to configure the settings.
Tip: Please also follow the instructions in the
Home Connect app.
Notes
¡ Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the Home Con-
nect app.
→ "Safety", Page 2
¡ Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the Home Connect
app.
¡ In networked standby mode, the appliance requires
a maximum of 2 W.
14.1 Setting up the Home Connect app
Install the Home Connect app on your mobile
1.
device.
14.3 Home Connect settings
You can adjust the Home Connect settings and network settings in your appliance's basic settings.
Which settings the display shows will depend on whether Home Connect has been set up and whether the appliance
is connected to your home network.
Basic setting
Home Connect as-
sistant
to go back to the
Possible settings
Start the assistant
Disconnect
Press "Time".
2.
.
To set the time, press the hour display or the minute
3.
display.
a The selected value is marked in blue.
Use the setting ring to set the time.
4.
To exit the basic settings, use
5.
main menu or switch off the appliance using
a The time is saved.
Start the Home Connect app and set up access for
2.
Home Connect.
The Home Connect app guides you through the en-
tire login process.
14.2 Setting up Home Connect
Requirements
¡ The appliance is connected to the power supply and
is switched on.
¡ You have a mobile device with a current version of
the iOS or Android operating system, e.g. a smart-
phone.
¡ The Home Connect app has been installed on your
mobile device.
¡ The appliance is receiving signals from the WLAN
home network (Wi-Fi) at its installation location.
¡ The mobile device and the appliance are within
range of your home network's Wi-Fi signal.
Open the Home Connect app and scan the follow-
1.
ing QR code.
Follow the instructions in the Home Connect app.
2.
Explanation
You can connect your appliance to the Home Connect app via
the Home Connect assistant.
Note: If you are using the Home Connect assistant for the first
time, only the "Start assistant" setting is available.
Home Connect en
to go back to the
.
17
Advertisement
Table of Contents
