Redragon K585 DITI ELITE - 2.4G Wireless RGB One-Handed Gaming Keyboard Manual

OS support

Windows XP/Vista/Win7/Win8/Win10

Basic Operation

How to connect the keyboard with a computer

Wired Connection

1. Take out the USB to USB C cable in the package and connect the keypad with your computer.
2. Slide the power switch on the bottom of the keyboard to Power On.
3. The computer will recognize and configure the keypad automatically.
4. The keypad will be ready for use when the configuration is finished. The LED of the keys will light on.
5. The keypad is under recharging whatever the power switch is put to ON or OFF.It may take about four hours for the keypad to be fully recharged.

Wireless Connection

1. Take out the USB receiver in the package and plug it into any available USB port on your computer.
2. Slide the power switch on the bottom of the keypad to Power On.
3. The computer will recognize and configure the keypad automatically.
4. The keypad will be ready for use when the configuration is finished. The LED of the keypad will light on.
5. Recharge the keyboard when the indicator (the LED on space bar) is flash in Red, the indicator will turn to gree after full charge.

Function Introduction

1. Computer USB port interfaces with the keyboard without needing to install drivers or software.
2. Detachable cable Type C to USB, cell phone cable are available.
3. There are 7 backlighting effects by press FN+Space: Go with the stream, The trial of Light, Ripple Graff, Flowers blooming, Pass without Trace, Stars, both ways
4. FN+ESC: Press and hold for 3 seconds, back to factory setting.
5. 4 Pre-set backlights modes:
   M1 (Default as F9) Go with the stream
   M2(Default as F10) The trial of Lights
   M3 (Default as F11) The Ripple Graff
   M4(Default as F12) Pass without trace
6. 7 Macro keys for recording: G1-G5 (G1-G5 default as F1-F5), ~, T.
7. How to recording by macro keys?
   1. Press REC key, get ready for recording.
   2. Select the light modes by press M1-M4.
   3. Select the macro key from 7 buttons (G1-G5, ~, T).
   4. Input the keys to be recorded
      (7 Macro keys G1, G2, G3, G4, G5, ~, T are not available for recording).
   5. Press REC to save the recording.

Noted: Every macro recording need to be coordinate with a light mode while it is recording and play.
For example: Record 123 on G1 at Light mode M1: REC → M1 → G1 → 123 → REC

8. How to play a macro?
   For example: M1 → G1
9. How to delete a macro?
   Press FN+ESC to delete all macro

How to Reconnect the keypad with the USB Receiver

The keypad may lost connection with the USB receiver for some occasional reasons such as strong magnet, violent vibration. So you may need to reconnect the keyboard with the USB receiver. In this case, unplug the receiver and plug it back again. Press FN+Q to pair. The space bard will light on in blue, then keyad LED change back to the previous light effect. The reconnection will be completed and you can use the keypard then.

FAQ

1. If the keyboard doesn't respond, please check if the keyboard USB cable is correctly inserted into the corresponding USB port on the computer, or try another USB port on the computer.
2. If you spill liquid on the keyboard, please remove keyboard USB cable from the computer immediately. Wipe up excess liquid and put the keyboard in a warm place (for instance, under a lamp) to let the keyboard dry naturally before using again.