Advertisement
4.1.4. Three solid green lights denote a full charge, at which point the light should be disconnected from the power supply.
4.2.
USE OF LIGHT
Warning: Ensure that the lenses are not pointing in a dangerous direction before switching on.
‰
4.2.1. To switch the light on, press the function switch (fig.1) to select the required function:
1st push: Top light.
2nd push: Front light, low output.
3rd push: Front light, high output.
4th push: Off.
4.2.2. When the light is switched on, the charge level will be shown by the number of green charge lights illuminated, three being a full
charge.
4.2.3. If only one green light is showing, the light requires recharging.
4.2.4. To employ the 360° function, pull the base downward to release the ball joint. The light can then be positioned in any attitude relative
to the base. Alternatively the back magnets or 360° hooks may be used.
BATTERY REMOVAL
Remove the 6 screws on the back of the lamp. Remove the back casing and disconnect the wiring from the circuit board. Remove the
battery mounting screws. Dispose of according to local government
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of prod-
ucts containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme.
Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When
the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved
containers and dispose of the product and fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic
Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact
your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts
without prior notice.
IMPORTANT: No Liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
guidelines.
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
LED3606R, LED3606G Issue: 2 - (H,3) 22/09/23
Advertisement
