Repair Service - Krups KH641810 Manual

„
Before pulling out the crumb tray, allow the toaster to cool for at least ten minutes after
completion of the preceding toasting operation (Fig. 27-28).
„
Unplug the toaster before cleaning.
„
Remove the crumb tray by pulling it out. Clean the toaster regularly (Fig. 30).
„
Never immerse the appliance in water or put it under running water.
„
Never use an abrasive sponge to clean the toaster. Clean it with a damp cloth and
wipe it with a soft, dry cloth (Fig. 29).
„
Wipe using a damp cloth then return the crumb tray to its place (Fig.30-31).
„
Never use the toaster without the crumb tray.
PROBLEM
The toaster does not work. Ensure the plug is properly connected to the socket.
The bread is stuck in the
appliance.
The bread is too brown or
not brown enough.
The bread pops out almost
immediately and is not
toasted.
Smoke is coming out of
the toaster.
The cord is damaged.
CLEANING V

REPAIR SERVICE

If the toaster is still not working, take it to an approved
KRUPS service center.
Unplug the appliance and leave it to cool. Remove the
bread carefully. Be careful not to damage the heating
elements when removing the bread. Never use a metallic
object to remove the bread.
Check the setting level selected. Select a lower level
if your bread is too brown, or a higher level if it is not
brown enough.
Ensure the freezing buttons have not been selected.
Ensure the handle has been lowered to the bottom.
If the bread still does not stay in the toaster, bring your
appliance to an approved KRUPS service center.
It is possible that the toasting level selected is too high.
Press the CANCEL (STOP) button to stop the toasting
cycle and unplug the appliance.
If the cord on the appliance is damaged, it must be
replaced in an approved KRUPS service center.
19
SOLUTION
EN