Power Acoustik PD-710B Owner's Manual page 29

99-6000
Table of Contents
99-6000
Kit Preparation
– Chrysler/Dodge/Eagle/Jeep/Plymouth** ............... 1.1
(Except: Grand Cherokee 1993-1995, Cirrus, Stratus, Sebring,
Sebring convertible, and Avenger)
– Chrysler Cirrus 1995-2000** ............................... 1.1
– Chrysler Sebring 1996-2000** ........... 1.1
(convertible)
– Chrysler Sebring 1995-2000**............................. 1.2
– Dodge Avenger 1995-2000** ............................... 1.2
– Dodge Stratus 1995-1999** ................................ 1.1
– Jeep Grand Cherokee 1993-1995** ..................... 1.2
– Plymouth Breeze 1996-1999** ............................ 1.1
Kit Assembly
– DIN radio provision .............................................. 1.2
**ATTENTION: Please refer to Section 6 for
Dash Disassembles.
Attention: This kit (99-6000) has been specially designed
with support ribs to insure structural integrity during shipping.
Please cut and remove these ribs from the radio opening
before beginning your installation.
Chrysler/Dodge/Eagle/
Jeep/Plymouth
(Except: Grand Cherokee 1993-1995, Cirrus,
Stratus, Sebring, Sebring convertible, and Avenger)
1. Cut and remove all mounting tabs on the
Radio Housing EXCEPT the shaded tabs.
2. Cut and remove the lower locating pin on
tab "A". It may be necessary to trim tabs "B"
for some applications.
Continue to kit assembly, p. 1.2
"B"
1.1
Kit Preparation 99-6000
Chrysler Cirrus 1995-
2000/Sebring
1996-2000, Dodge Stratus
1995-1999/Plymouth
Breeze 1996-1999
1. Cut and remove all mounting tabs on the
Radio Housing EXCEPT the shaded tabs.
2. Cut and remove the upper locating pin on tab "A".
Continue to kit assembly, p. 1.2
"A"
(convertible)
"A"