Table of Contents
Advertisement
•
Turn the knob to SF to freeze fresh food quickly. In this position, the
freezer compartment will operate at lower temperatures. After your
food freezes, turn the thermostat knob to its normal use position. If
you do not change the SF position, your appliance work will auto-
matically return to its last used thermostat position according to the
time indicated in the note. Return the thermostat switch to the SF
position and return it to normal use according to the time indicated
in the note.If the thermostat switch is in the SF position when your
appliance is first started, your appliance work will automatically re-
turn to the operation in the thermostat-3 position according to the
time indicated in the note.
•
The super mode will be cancel automatically after max 48 hours.
Additional information on the temperature
•
The temperature inside the appliance is influenced by many factors.
How you set the temperature control dial depends on the ambient
temperature, sun exposure, how often you open the door and the
amount of food stored. The middle setting of the dial is most optimal
in most cases.
•
Do not put food into the fridge freezer before it has reached its oper-
ating temperature, which takes minimum 4 hours.
•
Do not change the temperature settings due to the change in the
season of the year. The ambient temperature increase will be detect-
ed by the sensor and the compressor will be switched on automati-
cally for a longer period of time in order to maintain the temperature
set inside the chambers.
•
The slight changes in temperature are perfectly normal and may oc-
cur, for instance during the storage of great quantities of fresh prod-
ucts in the fridge, or when the door is open for a longer period of
time. This will not affect the condition of the stored foodstuff, and the
temperature will quickly return to its set value.
LIGHTING
This section applies to units factory equipped with incandescent lightbulb
and selected appliances equipped with LED lighting with E14 thread.
Replace the light bulb
•
Set the knob to "OFF/0/ ●", then unplug the appliance.
•
Remove the bulb cover (Fig. 18).
•
Replace the bulb with one having identical parameters as the factory
installed bulb (E14 thread, 220-240V, maximum dimensions: 26 mm
diameter, 55 mm length).
•
Replace the bulb cover.
•
Bulbs of a higher or lower power should not be used, only use bulbs
of the specification given above.
Note:
•
The light bulb must not be used for room illumination.
•
If Figure 18 is not shown in this manual, light source can only be
replaced by a qualified service technician.
•
If your refrigerator has LED lighting, contact the help desk as this
should be changed by authorized personnel only.
- 13 -
Advertisement
Table of Contents
