Table of Contents
Advertisement
2) While sliding the lock rod right, lift the
right end up and out of the guides.
CAUTION
• Do not remove the two inner lock rods and two
interlock buttons located underneath the top
lock rod. They do NOT need to be reversed.
7
Remove the
upper hinge pivot.
m
• Once the top lock rod has been removed,
the
hinge pivot can easily be removed
m
from the
hinge assembly on the upper
l
left and set aside.
8
Reverse the
upper hinge assembly and
l
hinge filler.
• Lift out the
upper hinge filler (on the
n
right) and set it aside.
• Carefully lift
the upper hinge assembly
l
(on the left) out of the outer door frame,
using a small flat blade screwdriver if
necessary. Rotate the
180 degrees and install it on the upper right
side of the outer door. You will need to
press firmly to install the hinge assembly.
• The
hinge pivot removed in step 8 will be
m
installed later.
n
hinge assembly
l
• Now rotate the
n
and install it on the upper left side of the
door.
9
Reinstall the
top lock rod.
g
• Rotate the top lock rod (removed in step 7)
180 degrees end for end from its original
position and reinstall it. The spring should
now be to the right of center, with the
spring on the side of the rod facing the top
of the door.
1) Insert the right end of the lock rod into
the right hinge assembly. Make sure the
rod is aligned with the guides in the door
panel.
2) Lower the rod into position, sliding it to
bypass the center handle, making sure to
align the lock rod with the guides all the
way across the door panel. When
released, the lock rod should slide
completely into the hinge assembly on
the right. Slide the lock rod back and forth
to make sure it is correctly positioned in
the guides and slides easily.
10
Reverse the
lower hinge bracket and
i
hinge assembly.
1) Remove the screw from the
hinge bracket (on the right) and lift the
hinge bracket out. Set it aside. Remove
the two screws from the
INSTALLATION
19
hinge filler 180 degrees
k
lower
i
lower hinge
k
Advertisement
Table of Contents
