Please read the instructions completely before beginning the installation.
Karlie Collection
Model Number: 1870EP
Flush both supply lines before installation, then shut off both supply lines.
Minimum hole size for the spout and handle trim is 1-1/4" and maximum of 1-1/2"
VACUUM BREAKER INSTALLATION
1
- Remove complete trim from vacuum breaker valve.
- Install bidet elbow into threaded outlet.
2
- Insert gasket into bidet wye and thread onto bottom of vacuum
3
breaker valve.
- Remove black plastic lock nut, nylon slip washer and one
4
black self-seating china seal.
- Insert diverter valve body up from below and reinstall black
5
self-seating china seal, nylon slip washer and black plastic lock
nut being sure to tighten firmly by hand.
- Thread trim cylinder onto vacuum breaker valve and tighten
6
firmly. Place handle on top and secure with brass screw. Insert
handle cap with arrow facing towards front of bidet.
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
Karlie Crystal Collection
Model Number: 1870RC
Rev 06/2016
Installation Instruction
KARLIE COLLECTIONS
Bidet Fitting
Handle Cap
Screw
Handle
Trim Cylinder
Black plastic lock nut
White Nylon Slip Washer
Black Soft Seating China Seals
Black Soft Seating China Seals
1/5