Table of Contents
Advertisement
UK
•
Press ON/OFF (1), on the DISPLAY (4) the central segments will light up, indicating that the
machine is powered.
On machines with an internal softener, when the regeneration cycle led lights up red (Fig. 11) you need
to run a regeneration cycle to restore proper function of the internal softener. Proceed as follows:
•
Empty and clean the dishwasher.
•
Remove the integral filter and open the salt container in the tub.
•
Pour in 250-300g of regeneration salt (1or 2mm grain size kitchen salt with no additives).
•
Close the container firmly.
•
Make sure the overflow has been removed
•
Close the door and switch the dishwasher on.
•
Press the PROGRAMME SELECTION button (2) to select the regeneration cycle.
•
Press the START button (3) to start a cycle.
•
The regeneration cycle lasts around 20 minutes.
•
The dishwasher will switch off when the cycle has completed.
N.B. Do not switch off the machine if a regeneration cycle is underway
With the machine on, hold the PROGRAMME SELECTION button (2) down for five seconds until "CC"
appears, followed by the number of wash cycles carried out during the machine life.
Door open
•
At the end of the day always drain the machine as described in the section Machine draining.
•
Disconnect the power supply by means of the main switch and close the external water cock.
•
Perform routine maintenance and clean the machine as described in the section Maintenance.
•
If possible, leave the door ajar to prevent bad odours building up inside the machine.
Page 8 of 12
INSTRUCTION MANUAL FOR DISHWASHERS
4.8 Turning the dishwasher off
4.9
Resin regeneration (*optional)
4.10 Displaying information
4.11 List of viewable messages
Number of cycles carried out
4.12 End of shift
Advertisement
Table of Contents
