Chapter 7 Maintenance And Troubleshooting; Maintenance; Troubleshooting Guide - Vizio VSB200 User Manual

VIZIO VSB200 User Manual
- If Error B, an unsupported sample rate is detected on the Optical (SPDIF) input, configure the 'audio
sample rate of the audio source device to be either 44.1 KHz or preferably 48KHz.
- If Error C, Over-current detection is indicated, reduce the volume setting of the Sound Bar and
Subwoofer temporarily, and turn the unit off for a short period and back on to reset the circuitry. If this
indication continues to occur, then reduce the volume level for the particular source content being played.
- If Error D, Thermal shutdown, is indicated, turn off the Sound Bar and verify the ventilation slots in the
Sound Bar are clear, the Sound Bar has proper ventilation and is not being operated in an environment
that is too hot. If these conditions exist, reduce the volume level for the particular source content being
played.
- An error condition that is not detected or indicated by the LED error indications is distortion of audio.
The Sound Bar is designed for standard line-in level input signals which are a MAXIMUM 2 Volt RMS.
The Sound Bar is not intended to be connected to the output of an amplified audio source such as a
Home Theater speaker output or MP3 Player headphone jack. Doing so may damage the Sound Bar.
Maintenance and Troubleshooting

Maintenance

Maintenance Maintenance
Chapter 7 Chapter 7
Chapter 7 Chapter 7
Maintenance Maintenance Maintenance Maintenance
Important
1. Make sure that the power cables are removed from their sockets before cleaning the Sound
Bar.
2. Do not use volatile solvent (such as toluene, rosin and alcohol) to clean the Sound Bar. Such
chemicals may damage the Sound Bar housing.
Cleaning the Housing and Remote Control
1. Use a soft cloth for cleaning.
2. If the housing is seriously contaminated, use a soft cloth moistened with diluted neutral
cleaner to clean the display. Wring water out of the cloth before cleaning to prevent water
from penetrating into the housing. Wipe the housing with a dry cloth after cleaning.

Troubleshooting Guide

Troubleshooting Guide
Troubleshooting Guide Troubleshooting Guide
If the HD Sound Bar fails to operate, or the performance changes dramatically, check the operation in
accordance with the following instructions. Remember to check the peripherals to pinpoint the source of
the problem. If the HD Sound Bar still fails to perform as expected, contact the VIZIO for assistance by
calling 1-877-MYVIZIO (1-877-698-4946) or e-mail us at
Problem
No power.
No sound.
and Troubleshooting and Troubleshooting and Troubleshooting
Solution
Make sure AC power cord is securely connected to an AC socket and to the
AC receptacle on the AC/DC Adapter.
Make sure the power LED on the AC/DC adapter is glowing green.
Plug another electrical device (like a radio) to the power outlet to verify that
the outlet is supplying power.
Press the Power button on the remote control or the top of the HD Sound
Bar.
Press the Volume + (Up) button on the remote control or the top of the
22
www.VIZIO.com
techsupport@vizio.com