Advertisement

Quick Links

START & STOP BATTERIES (EFB, AGM ) AND
TRADITIONAL BATTERIES (AGM, GEL & CONVENTIONAL)
THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS. PLEASE SAVE THESE INSTRUCTIONS.
KEEP WITH OR NEAR CHARGER AT ALL TIMES.
1.
WARNING – RISK OF EXPLOSIVE GASES.
a.
Working in the vicinity of a lead-acid battery can be dangerous. Batteries generate explosive gases during
normal battery operation.
b.
For this reason it is of the utmost importance that prior to each use of your charger, you read and follow the
instructions provided exactly:
c.
The appliance is not intended for use by young children or infirm persons without supervision. Young
Children should be supervised to ensure that they do not play with the appliance.
2.
To reduce risk of a battery explosion, follow these instructions and those marked on the battery.
3.
NEVER smoke or allow an open spark or flame in the vicinity of the battery or engine.
4.
CAUTION – To reduce the risk of injury, use the charger for charging a rechargeable lead-acid battery only. It is not intended to
supply power to a low-voltage electrical system or to charge dry-cell batteries. Charging dry-cell batteries may cause them to
burst and cause injury to persons and damage to property.
5.
Do not expose the charger to moisture, rain or snow. For indoor use only.
6.
Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock,
or injury to persons.
7.
To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting the charger.
8.
Make sure cord is located so that it cannot be stepped on, tripped over, or otherwise subjected to damage or stress.
9.
Study all the battery manufacturers' specific precautions such as removing or not removing cell caps while charging and
recommended rates of charge.
10. Do not use the battery charger unless the battery voltage matches the output voltage rating of the charger.
11. Do not operate the charger in a closed-in area or restrict ventilation in any way.
12. Do not operate the charger with damaged cord or plug. If the supply cord cannot be replaced and the cord is damaged, the
appliance should be scrapped.
13. Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to a
qualified repair station or local dealer.
14. Do not disassemble the charger. Take it to a qualified repair station or local dealer when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
15. To reduce risk of electric shock, unplug the charger from an outlet before attempting any maintenance or cleaning.
Important notice : DO NOT use other DC output cords than the one supplied or use an extension cords as it could result in
damage to the unit which will not be covered by warranty.
SC POWER SC70
INSTRUCTION MANUAL
MODEL SC POWER SC70
SMART BATTERY CHARGER FOR
9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SC70 and is the answer not in the manual?

Questions and answers

Summary of Contents for SC POWER SC70

  • Page 1 INSTRUCTION MANUAL MODEL SC POWER SC70 SMART BATTERY CHARGER FOR START & STOP BATTERIES (EFB, AGM ) AND TRADITIONAL BATTERIES (AGM, GEL & CONVENTIONAL) THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS. PLEASE SAVE THESE INSTRUCTIONS. KEEP WITH OR NEAR CHARGER AT ALL TIMES.
  • Page 2 Connect and disconnect DC output clips only after setting the charger switches to off position and removing AC cord from the electric outlet. Never allow clips to touch each other. Follow these steps when battery is installed in a vehicle. A spark near battery may cause a battery explosion. To reduce risk of a spark near battery: SC POWER SC70...
  • Page 3 OBD II cable for data backup during battery replacement. Always connect or disconnect the output leads before plugging into AC power. For all battery types: Connect the red positive (+) lead to the positive terminal of the battery. Connect the black negative (-) lead to the negative terminal of the battery. SC POWER SC70...
  • Page 4 START & STOP BATTERY EFB battery charge mode at 7A max. 12V 7A 12V lead acid battery charge mode at 7A max. TRADITIONAL BATTERY 12V 1.8A 12V lead acid battery charge mode at 1.8A max. AGM, GEL & CONVENTIONAL SC POWER SC70...
  • Page 5 (Location of OBDII underneath the dash board or beside the fuse box) The Power & Car Memory SAVER Saver LEDs will be glowing during operation. ATTENTION: PLEASE ENSURE THE PROPER CONNECTION, CAR MEMORY SAVER & POWER LEDs ARE GLOWING BEFORE BATTERY REPLACEMENT, OTHERWISE THE ELECTRONIC DATA WILL LOSE! SC POWER SC70...
  • Page 6 C. The charged battery is larger than the charger marked capacity (shown in manual) Please recharge with larger capacity charger. Lead –Acid Battery Charging Mode -START & STOP BATTERY (EFB , AGM ) -TRADITIONAL BATTERY AGM, GEL & CONVENTIONAL 9 Stage Charge, Conditioning and Maintenance Process Map SC POWER SC70...
  • Page 7 The battery can be left safely connected to the charger indefinitely. The charger will constantly monitor the battery and “turn-on again as needed to maintain the battery at a full state of readiness. *Asterisk denotes a phase in Battery Recovery Processing SC POWER SC70...
  • Page 8 Charge and maintenance capacity ranges are suggested only as a guide for battery charger selection and application based on varied customer charging and maintenance requirements. Please be sure to follow safety and use information in user guide for correct product application and use. SC POWER SC70...

Table of Contents