Table of Contents
Advertisement
Basic operation
7 Basic operation
7.1 Switching on the appliance
Press
.
▶
a The appliance starts at fan setting 2.
7.2 Switching off the appliance
Press
.
▶
7.3 Setting a fan setting
Slide your finger over the settings area
▶
7.4 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
Slide your finger to the right over the settings area
▶
until
appears on the display.
a After approx. 6 minutes, the appliance automatically
switches to fan setting 3.
7.5 Switching off intensive mode
Slide your finger to the left over the settings area
▶
.
7.6 Switching on the boost function
The boost function is a short-term maximum power set-
ting which can be activated in any fan setting.
Press .
▶
a After approx. 20 seconds, the fan automatically
switches back to the fan setting that was previously
set.
7.7 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
Note: If the intensive mode is activated, the fan run-on
cannot be switched on.
Press
until
appears on the display.
▶
a The fan run-on starts at fan setting 1.
a The appliance switches off automatically after ap-
prox. 10 minutes.
7.8 Switching off the fan run-on
Slide your finger to the right over the settings area
▶
.
7.9 Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
Press
.
▶
7.10 Switching off automatic mode
Press
.
▶
1
Depending on the appliance specifications
a The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a Automatic mode runs for a maximum of four hours.
7.11 Sensor sensitivity
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
.
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡ Factory setting: 3
¡ Lowest setting: 1
¡ Highest setting: 5
7.12 Setting the sensor sensitivity
Requirement: The appliance is switched off.
Press and hold
1.
a The setting is displayed after approx. one second.
Slide your finger over the settings area
2.
Release
3.
7.13 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Note: Colour temperature settings are available in the
Home Connect app provided the appliance has this
function.
Press
▶
7.14 Setting the brightness
Press and hold
▶
reached.
7.15 Switching on emotionLight Pro
You can switch on the emotionLight Pro independently
of the ventilation system.
Press
▶
7.16 emotionLight Pro - Setting the
brightness
Press and hold
▶
reached.
7.17 emotionLight Pro - adjusting the
colour
Requirement: The appliance is switched off.
Press
1.
2.
Press
set.
.
to save the setting.
.
until the required brightness is
.
1
until the required brightness is
1
.
or
repeatedly until the required colour is
Basic operation en
.
1
7
Advertisement
Table of Contents
