Panasonic Palmcorder PV-D407 Operating Instructions Manual page 7

Charge the Battery Pack
Charge the Battery Pack fully
before operation.
POWER
Lamp v
CHARGE
Lamp
Note:
After recharging the Battery Pack about 5 times,
use the BATTERY REFRESH feature as
explained on page 8.
Use the Battery Pack
JL
Plug in the AC Adaptor.
POWER Lamp lights.
&
Insert the Battery
® Align the right side of the Battery with
the line on the AC Adaptor.
(B) Press the Battery down and slide it in
the direction of the arrow.
CHARGE Lamp lights. When charging is
done (about one and a half hours) the
lamp goes out.
^Remove the Battery
Slide the Battery out and lift up.
The useful operation time of the Battery will
gradually decrease after repeated use and
recharging. The Battery is no longer
serviceable
if
the operation time
is
very short,
even after a sufficient charge.
With a fully charged Battery Pack, you will have a maximum of about one and a half
hours of continuous use. (If the Built-in Light is used, battery operating time decreases.)
. Attach the Battery
® Align the Battery with the top of the
mounting surface.
(g) Press it into place until it locks with a
click.
Remove the Battery
While sliding the BATTERY RELEASE
button, remove the Battery.
7