Operation; Switching On And Off - Philips AS 9300 Manual

CONTROLS
Fig. 2
G@) POWER switch, for switching the entire unit
on/off.
(@) Graphic equalizer tone controls.
@) Dial pointer with on/off indicator.
G) Dust cover for record player.
G) (NOT ON ALL VERSIONS) LW/MW wave range
selector (some versions SW/MW).
©) AM/FM wave range selector (some versions
MW/FM).
@ STEREO/MONO selector.
FREQUENCY TUNING control, for tuning into
radio stations.
@) FM STEREO indicator: lights up when an FM
broadcast in stereo is received and selector @is
in the STEREO position.
(a) VOLUME control.
(@) DYNAMIC BASS BOOST button with indicator.
(2 CD.TV selector with indicator.
(3) PHONO selector with indicator.
(3) Cassette holder deck IL.
¢3) PHONES socket (6.3 mm) for connecting stereo
headphones (impedance 8-1000 ohms). The
loudspeakers are automatically switched off
when using headphones.
PAUSE button: for stopping the tape transport in
deck I momentarily.
WIND button for deck II: for fast forwarding the
tape.
(2 REW button for deck I: for fast rewinding the
tape.
PLAY button for deck II for starting playback.
STOP/EJECT button for deck I.
@i) PAUSE button: for stopping the tape transport in
deck I momentarily.
@2 WIND button for deck I: for fast forwarding the
tape.
@) REW button for deck I: for fast rewinding the tape.
@3) PLAY button for deck I: for starting playback.
@) RECORD button: to make a tape recording.
@) STOP/EJECT button for deck I.
@) Cassette holder deck I.
@) TUNER selector with indicator.
@) TAPE selector with indicator.
62) HIGH SPEED DUBBING selector with indicator,
for selection of normal or high tape speed when
dubbing.
Record player, Fig. 3 (not on all versions)
Z\ Adapter for 45 rom. records.
ZX Transit screws.
AX Cue lever, for lifting and lowering the tone arm.
Z\ Speed selector 33-45, for selecting the speed.
AX Fixing clip for the tone arm.
OPERATION
SWITCHING ON AND OFF
@ Use POWER switch G) to switch on the unit. The
on/off indicator @) will light up.
@ To switch off, press POWER switch @) again.
Indicator @) will fade.
Note: To prevent damage first switch off the record
player or tape decks.
— The record player: by moving lever A\ to the ¥
position and then moving the tone arm outwards.
When the arm reaches the support, the turntable will
stop.
— The tape decks: by pressing the STOP/EJECT
button once.
AMPLIFIER
@ Turn the volume control to. minimum (fully
anti-clockwise).
e@ Press one of the selector buttons CD.TV @,
PHONO (3), TUNER @e), or TAPE @). The appropriate
indicator will light up.
@ Turn the volume control @ to the desired level.
@ Adjust the tone using the graphic equalizer
controls @). Press the DYNAMIC BASS BOOST
button (1) for additional amplification of the bass
reproduction.
TUNER
@ Select tuner mode (radio) with TUNER button @é).
@ Select the desired tuning range: MW or LW (for
some versions SW) using selector () (with selector
(©) to AM). For the reception of FM broadcasts, set
selector () set to FM.
@ Tune to the desired station with FREQUENCY
TUNING knob (8).
@ if there is interference when receiving FM stereo
broadcasts, put STEREO/MONO button @) in the
MONO position. STEREO indicator @) will then
extinguish.
Note: In the MONO position any stereo noise
resulting from weak stereo reception will disappear.
Under normal circumstances, leave this button in the
STEREO position.
RECORD PLAYER (not on all versions)
@ Select the phono mode with PHONO Selector
button (9.
e@ Place a record on the turntable. For records witha
large centre hole, use the adapter A\.
@ Remove the stylus protector by pulling it forwards.
e Use selector A\ to select the appropriate speed.