Table of Contents
Advertisement
C
onnecting Other Equipment
Ofolalel
sre dlate m= AO1 ata ate(-romelt-Tome](-h'.-1 aro] am Or-lan lore} colcl mare) @=reLelselolzcomwildam-lamom aie(-lomolel celui ast lel.
<>:
Signal flow
(Front of TV)
"=r
wn
VMC-810S/820S
(not supplied)
m=meoweenunoveeae
Preparing for use
1
2
Turn on the TV.
Press TV/VIDEO on the TV or on the Remote
Commander so that "VIDEO 1," "VIDEO 2" or "VIDEO 3"
appears on the screen.
VIDEO 1: for equipment connected to VIDEO 1 IN
VIDEO 2: for equipment connected to VIDEO 2 IN
VIDEO 3: for equipment connected to VIDEO 3 IN
About the CONTROL S jacks
Make the following connections to control the TV and
connected equipment with one Remote Commander.
1
Connect the equipment to CONTROL S to contro! the TV
with the other equipment's remote commander.
Connect the equipment to CONTROL §S to control the
other equipment with the TV's Remote Commander.
6 } Chapter 1: Setting Up
(Rear of TV)
Operating the equipment
Same as p. 15.
To return to TV mode
Press TV/VIDEO or CHANNEL +/- on the TV, or press TV/
VIDEO, CH +/- or
0-9 and ENTER on the Remote
Commander so that a channel number appears on the
screen.
Notes
© {f you try to use equipment that is connected to the front
CAMCORDER/VIDEO 3 INPUT and rear VIDEO 3 IN jacks at the
same time, the picture will be distorted. Be sure you turn off one
piece of equipment first.
You can label each of the video input modes (p. 57).
You do not need to select a video mode when you use the direct
play function (pp. 74 - 75).
If you connect a monaural VCR, connect the audio output of the
VCR to the L (MONO) jack of VIDEO IN (1, 2 of 3). The monaural
sound will be heard from both speakers.
If equipment is connected to the rear VIDEO 3 IN S video jack,
and you want to watch
the signal input from the front
CAMCORDER/VIDEO 3 INPUT jacks, set S-VIDEO to "OFF."
e
Advertisement
Table of Contents
