Advertisement
4. INSTALLING THE CHARGER
Unit System Diagram
Note: This diagram is for reference only. No cables, fuse/breakers, batteries, or solar panels are supplied with
this unit. Local rules and regulations should be followed when installing this unit.
WARNING: KISAE Technology recommends that all wiring be done by a certified technician
or electrician to ensure adherence to the applicable electrical safety wiring regulations and
installation codes. Failure to follow these instructions can damage the unit and could also
result in personal injury or loss of life.
CAUTION: Before beginning your unit Installation, please consider the following:
• The unit should be used or stored in an indoor area away from direct sunlight, heat,
moisture, or conductive contaminants.
• When placing the unit, allow a minimum of three inches of space around the unit for
optimal ventilation.
Mounting the Charger:
• Choose an appropriate mounting location.
• For installing in an indoor location, the unit should be mounted vertically
(with the battery terminals facing downwards). This provides the best
thermal performance and drip protection. The unit should NOT be
mounted upside down.
• For installing in a boat or marine environment, the unit should only be
mounted vertically (Battery Terminals facing downwards) to provide
adequate drip protection.
• Use the base of the charger as a mounting template to mark the
positions of the screws.
• Drill the 4 fixing holes and place the Charger in position and fasten the
unit to the mounting surface.
Note: The charger is designed to be permanently mounted.
Advertisement
