Table of Contents
Advertisement
TO YOU THE OWNER
This Owners Manual has been especially prepared
to bring to your attention all information needed to
operate and maintain your Economy tractor with
maximum efficiency. Read these instructions care-
fully before assembling or operating the tractor.
Through proper care and operation, as explained
in this manual, you will obtain long, efficient service
and trouble free operation from it.
Information regarding operation and maintenance of
the tractor engine is not included in this manual.
A separate engine instruction manual is included with
each tractor and should be consulted for all infor-
mation concerning adjustments and operation.
REGISTER YOUR TYPE AND SERIAL NUMBER
Register your tractor type number, serial number
and engine serial and type number in the space
provided below and always refer to them when writ-
ing for information or ordering parts. Complete
the registration card received with the tractor and
return to the factory. A nameplate showing type
and serial number of the tractor is attached to the
frame. The engine type and serial number is on
the engine nameplate.
TRACTOR TYPE NO
,
TRACTOR SERIAL NO
ENGINE TYPE NO
ENGINE SERIAL NO
SPECIFICATIONS
Engine:
Four cycle air cooled Clin-
ton Model 700 Engine. 2
H.P. at 3600 RPM (max.
ground speed) equipped with
rope starter and rotating air
intake screen.
Wheels:
Reversible steel flange
wheels with 4 inch rim.
Tires:
5-12 Traction type Garden
Tractor tires, air filled.
6 lb air pressure recom-
mended.
Final Drive:
Enclosed stamped steel,
grease filled gear case with
machined and steel gear
train. Case sealed to ex-
clude dirt and moisture.
Cast iron wheel hubs driven
by double acting ratchet
pawls.
Primary Drive:
V-Belt with ball bearing,
belt idler type, clutch oper-
ated by a squeeze grip
clutch control on the L.H.
handle bar.
Bearings:
Needle type precision rol-
ler bearings in entire drive
excepting wheel hubs.
Handle Bars:
Handle bars are adjustable
to convenient height for op-
eration.
2
Front Hitch:
Patented "Snap Hitch." No
tools required for attaching
implements on loose parts.
Rear Hitch:
"Trigger Hitch." No tools
required for attaching im-
plements, no loose parts.
Power Take Off:
For front mounted
attachments
2-1/2 inch effective outside
diameter semi-deep groove
sheave. Adjustable belt fin-
gers to give better declutch-
ing of the attachment drives.
Attachment idler clutch con-
trol linkage is adjustable
and is a part of the tractor
itself.
Crop Clearance
9-3/16 inches
Fuel Capacity:
2 qt.
Speeds:
Forward only. Variable
1.5 to 2.9 M.P.H. at 3600
RPM (max. governed engine
speed.) Lower speeds may
be attained by reducing en-
gine speed.
Width Dimensions:
Overall over wheels
Wheels set in
Wheels set out
Overall including
offset handle bars
22.5 inches
23.24 inches
Wheels set in 29.4 inches
Wheels set out 32.24 inches
Tread Width:
Wheels set in
Wheels set out
17.5 inches
24 inches
Advertisement
Table of Contents
