Maximum Weights On Supports And Crossbars; Operation; Workpiece Installation; Cleaning, Maintenance And Troubleshooting - Bessey EBH Series User Manual

5.3 Maximum weights on supports and crossbars

Table for maximum permitted weights on the horizontal support and the crossbars:
On
Type
supports
EBH 2412 -
EBH 201 50 kg
EBH 202 100 kg
EBH 203 150 kg
• Keep to these maximum weights and avoid tilting the heater or damaging the supports,
crossbars or hinge.
CAREFUL!
Always handle induction crossbars with care. They are damaged easily when dropped,
knocked against something, etc. Store them immediately after use.

6. Operation

6.1 Workpiece installation

• Position the workpiece and crossbar (according to chapters 5 & 6).
• Switch on the main switch. The heating starts, you will hear a slight humming noise.
• It is advised to monitor the temperature rise of the workpiece with an external
thermometer.
• Wear heat-resistant gloves. Place the crossbar with the workpiece on a clean surface.
Install the workpiece without delay and prevent it from cooling down.
• Switch off the main switch when heating is ready.

7. Cleaning, maintenance and troubleshooting

• Store in a dry place, free from frost and damp.
• Clean with a dry cloth. Never clean with water.
• Keep the bare parts of the poles clean. Lubricate regularly with acid-free grease for better
contact with the crossbars and to prevent corrosion.
WARNING!
• Carrying out the right maintenance and following the instructions is important.
• Contact your supplier if in doubt about the correct functioning of the device.
• Repairs must be carried out by the manufacturer or a specialist approved
by the manufacturer.
© Bessey Tools
7 10 14
1 kg 2 kg 3 kg
1 kg 2 kg 3 kg
- 2 kg 3 kg
- - -
Size of crossbars (mm)
20 30 40
5 kg - 20 kg
5 kg 10 kg 15 kg
5 kg 15 kg 20 kg
10 kg 15 kg 25 kg
50 60 70
- - -
- - -
- - -
40 kg 45 kg 50 kg
15
EN
FR