Sony DAV-HDX265 Operating Instructions Manual page 11

• When you install the wireless kit WAHT-SDI (supplied with DAV-HDX267W only) in the DIR-TCI slot, you can
enjoy wireless perlk)rnmnce. For details, see "Connecting Other Components" (page 24) and the operating
instructions of the WAHT-SDI.
(_) Connecting the Speakers
Required cords
Tile connector arm color tube of tile speaker cords are the same color as the label of the jacks to he
connected.
To the SPEAKER jack
m
• Do not catch the speaker cord insulation in the SPEAKER jack.
To avoid short-circuiting the speakers
Short-circuiting of tile speakers may danmge tile system. To prevent this. be sure to follow these
precautions when connecting tile speakers. Make sure the hare wire of each speaker cord does not touch
another speaker terminal or the bare wire of another speaker cord, such as shown below.
Stripped speaker cord is touching
another speaker terminal.
Stripped cords are touching each other
due to excessive removal of insulation.
Alter connecting all the components, speakers, and AC power cord (mains lead), output a test tone to
check that all tile speakers are connected correctly. For details on outputtiug a test tone, see page 77.
If no sound is heard l?om a speaker while outputting a test tone, or a test tone is output fl'om a speaker
other than the one currently displayed on tile Setup Display, the speaker may he short-circuited, lfthis
happens, check tile speaker connection again.
• Be sure to match the speaker cord to the appropriate terminal on the components: (_ to (_, and Q to Q. If the cords
are reverse& the sound will lack bass and may be distol_ed.
11GB